Spray For Mold In Attic

Customers sing the praises of this mold and mildew stain remover from rmr 86.

Spray for mold in attic.

Mold growth in an attic comes as a consequence of excess moisture. These options will only be sufficient if very little penetration of the wood has occurred so if the. The insulation fill was about an r 16 there were no intake vents at the eaves the bath vents were venting into the attic and the whole house humidifier was adding even more moisture during the winter months. Defects that commonly lead to the growth of mold in an attic include roof or chimney leaks inadequate insulation or improper ventilation.

It s a bit smelly and it s not one of the cheaper options 17 versus lower quality options in the 9 12 range but if you want the best this is it. Other options for limited areas of mold include spraying it with a mixture of water and tea tree oil or water and vinegar. Attics usually have a passive ventilation system in which outside air comes in through the soffit eave vents at the bottom warms up in the attic and escapes through the can or ridge vents at the top because hot air rises. Attic mold is the result of some type of construction defect.

While damp and warm climates are a prime breeding ground for our fuzzy friend other conditions that bring mold include lack of ventilation and proper sheathing. The best way for getting rid of mold in the attic black mold and any other mold is to remove it from the surface it s growing on or remove the contaminated surface. After 60 hours of research testing we re comfortable recommending the rmr 86 instant mold mildew stain remover as the best mold killer for your dollar due to its effectiveness versatility and ease of use. High humidity in a space like an attic can lead to mold and a spill in a carpeted area of your home that isn t quickly taken care of can also lead to mold under the carpet.

The most common cause of attic mold by far is blocked or insufficient ventilation of the attic space. There is no point in attempting to get rid of attic mold unless you first fix whatever problems led to the growth of the mold in the first place. The following getting rid of mold cleanup methods are recommended by epa and all of them can be applied in the attic assuming that it is a small area up to 10 sq. If your attic mold is limited to a very small area you may be able to use a power sander or a wire brush to remove it.

The homeowner noticed moisture condensation occurring in the attic and since then black mold has developed on the osb board.