Standing Seam Metal Roof Section

Metal roof panels 074113 1 section 074113 standing seam roof panels this specification is applicable for imetco series 300 structural standing seam panel system with separate mechanically seamed batten cap.

Standing seam metal roof section.

The recommended dimensions should be specified from the table below. Colonial seam continuous standing seam metal roof panel with an integral seam. These pans run parallel to the slope of the roof and are joined to adjacent pans with double locked standing seams. Its unique mechanical lock design profile forms a weather tight unit and unlike some other types of panel metal roofs no rivets or screws are exposed on the surface of the panels.

Superseded by ufgs 07 41 13 metal roof panels note. The minimum slope for standing seam roof systems shall be one quarter unit vertical in 12 units horizontal 2 percent slope. Snap on standing seam. As panel options have grown however it is common to see clipless panels included in this product family as well.

138t and 238t systems are classified as symmetrical standing seam systems that feature mechanically seamed caps. Part 1 general 1 1 related documents retain or delete this article in all sections of project manual. In the purest form they are panels with male and female legs that are engaged and installed with clips to the roofing substructure. High snap on standing seam panel.

Our standing seam is also available in tapered and curved designs. Interlock standing seam metal roof panels are a fully interlocking system. Architectural metal panel roof systems are considered water shedding assemblies intended to shed water by means of the roof slope. The last published pdf version of this section is available in the previous release in the ufgs archives.

Standing seam panels are a product family of metal roofing. 138t and 238t standing seam roofing systems while standing seam roofing systems have been used for generations 138t and 238t panels feature technological advances in roofing that set a new standard for standing seam performance. Clipless one piece positive locking standing seam panel that provides a timeless roof appearance. This section provides generic guidelines for the fabrication and application of architectural standing seam metal roofing systems over a ventilated attic space.

Pac 150 90 single lock. Division 07 thermal and moisture protection. Pac 150 180 double lock. Redi roof standing seam.