Stchimney Roof Counter Flashing

In good quality work the top is bent and set 1 to 11 2 inches into a mortar joint reglet.

Stchimney roof counter flashing.

Cap flashings should be fastened to the chimney only. There are different types of flashing for different chimneys but we ll focus on flashing designed for round metal pipe. All you need to complete this project are a few tools and a little know how. Chimney flashing is a generic term for any metal or rubber boot used when a vent pipe passes through a roof.

Water sheds from off the brick chimney surfaces down over the outside edge of the step flashing. It directs water away from the chimney and seals off the gap between the pipe and the roof. It involves two pieces of flashing. Pound the flashing into the grooves and fasten with the drive in expanding anchors.

Properly flashing a chimney is important to prevent water from leaking between the chimney and roof and getting into the building s walls. Step 1 cut the mortar joint. Counter flashing counter flashing is placed over the step flashing parallel to the chimney. Bottom the bottom cap flashing or counter flashing is a single piece of metal that covers the vertical portion of the base flashing.

Cut the side cap flashing to fit the angle of the roof so it overlaps each lower cap flashing at least 2 in. The installation of counter flashing against a chimney works together with the base and step flashing to form a waterproof system for your roof. Three types of flashing are typically used on each roof. The counter flashing extends from the layer of bricks and then bends down overlaying the top edges of the primary step flashing.

Base flashing step flashing and counter flashing. Not only will it prevent leaks but it will also extend the life of your chimney s masonry. Bend a piece of cap flashing to fit around the top corner of the chimney and add the cap flashing across the back of the chimney. Counter flashing provides an added measure of protection.

If the systems are a masonry chimney the counter flashing should be ground into the system to ensure that the majority of the water cannot bypass the seam of the counter and step flashing. The second piece the counter flashing is embedded into the masonry of the chimney. Flashing directs rainwater away from these junctions preventing subsequent leaks and water damage. Counter flashing is often used to flash chimneys.

The counter flashing is either cut into the brick face or embedded into the mortar between brick layers.