Step By Step Roofing Shingles

Dispose it properly in the garbage or recycle bins.

Step by step roofing shingles.

4 preparing the roof surface for shingles drip edge installation after wood decking is prepared we install drip edge at all edges of the roof. If the plumbing vent is close to the peak of the roof lap the shingles over the peak of the roof. Adhere the joint where the cut edges of the shingles meet the dome with roofing tar. Do not leave broken shingles lying around.

Throw old and damaged shingles properly. Trim the shingles away from the ridge vent hole. You or other people may slip on it. Required tools for this how to shingle a roof project chalk line hammer roof harness utility knife.

Working at heights on a roof presents fall hazard risks and. Roll out a single layer of roofing. Continue to chalk additional guidelines based on the width of the shingle through at least four courses rows across. Also should i cut off the 1 4 overhang on the.

Drip edge is a. Install a layer of roofing insulation as recommended by the roofing manufacturer. Before laying down shingles you need to protect the roof with sheathing. Proper steps to shingle a house roof preparation.

If there is more than one layer of old shingles or if the single layer is extensively warped or damaged. Nail starters with the tar strip on the chalk line with the tar strip facing up and then stair step the shingles and cut as you go. We basically simplified the process on how to reshingle a roof. Attach he ridge cap shingles with two nails each.

Asphalt roofing shingles simply rely on the force of. Hammer down any large nails that are exposed by the removal. Understand the physics of how a sloped shingle roof works. Starting at the bottom of the roof map out a guideline with chalk.

If i m re roofing shingles over old shingles should the starter course line up with the drip edge. Ice and water shield installation next step is installing ice and water shield which is a special type of roofing. How to install asphalt shingles 1. Not helpful 6 helpful 1.

Step one in any roofing project is always safety first. Start from the top of the roof and remove the old shingles along with the flashing underlayment and vents.