Steps To Putting On A Metal Roof

Even asphalt gets damaged from repeated traffic something that isn t necessarily true of metal.

Steps to putting on a metal roof.

This is not a complete install only basic install on a bungalow i. Start in a bottom corner left or right of the roof then roll it out until it gets to the other end. When you start with the first metal panel position it so that it overhangs the edge by at least 4 inches. Most codes now allow no more than two layers of roofing before.

Metal roofing is also available in the form of shingles. As a rule of thumb you want it to be tight enough to hold it in place but not so tight that you ve dimpled the metal. First focus on removing the oldest shingles that are sticking out as well as any flashing or vents. In fact metal roofs can stand up to you walking on them better than ceramic tiles and some other roofing systems.

Put the underlayment membrane down to form the base. Lay the starter row of metal shingles at the drip edge and affix to the roof with metal roofing nails. Covering your existing asphalt shingles with metal roofing might be worth the expense. Can you avoid tearing off your old asphalt shingle roof by putting a steel roof over it.

Space the screws about 12 in 30 cm apart down the entire piece of metal. Take your first sheet of metal and place it on the roof so that it overhangs the edge at least 3 4 in 1 9 cm. Install metal roofing sheets. 1 remove the shingles before installing the metal roof the first way to install a metal roof over shingles is by completely removing the old shingles before installing the new metal roof.

Now slide a washer onto a 1 inch wood screw and use your screwdriver to secure it to the plywood of the roof. A benefit to doing it this way is that you can see if there is any rotten plywood that needs to be replaced before installing the new roof. Metal roofing sheets have to be installed one at a time. Place a sheet from top to bottom on a section of the roof.

4 steps for. Here are some pros and cons. Use 1 4 inch metal wood screws to attach the metal sheets to the wood slat board base. Use your neoprene washer head screws to secure the metal to the sheathing.

Then remove the rest of the roof including all the shingles. Make sure that you hammer in a 1 5 inches 3 8 cm nail every 12 inches 30 cm so it stays down. Need a new roof. Generally speaking it is as safe to walk on a metal roof 30 or 50 years after installation as the day it was installed.

Remove any nails sticking out and reposition any metal gutters so that water flows properly off the roof.